Wall mold in Jonesboro usually starts with water inside the cavity, from plumbing, a roof or window leak, or dampness at a lower wall. Getting rid of it means fixing that water source, removing affected drywall and insulation under containment, and drying the framing before rebuilding. Call the number on this page to be connected with a local mold remediation company in Jonesboro.
Jonesboro houses and wet walls
Jonesboro is the Clayton County seat, a small city of about 4,200 people roughly 16 miles from Atlanta, with a historic district downtown along Main Street and the old Macon and Western rail line. Older houses may have plaster or early drywall over framing that has seen decades of small leaks, while newer construction tends to run more plumbing inside interior walls. Either way, the drivers are humid summers, heavy storms and red clay that keeps foundations damp. Clayton County was among the Georgia counties under a state of emergency during the September 2009 floods.
What to do now
- Stop the source. Turn off water at a leaking fixture or the main, and tarp or patch a roof leak if it is safe to do so.
- Start drying. EPA says to dry wet materials within 24 to 48 hours; run fans and a dehumidifier and keep the room closed.
- Do not cover it up. Paint, caulk or new trim over a moldy wall hides the problem; EPA advises against it.
- Protect people. EPA says people with asthma or weakened immune systems should stay away from moldy areas.
- Record it. Photos, dates and any plumber's invoice help with insurance or a landlord.
- Get the wall mapped. A moisture meter shows how far the wet area runs before any cuts are made.
Signs and likely causes
| What you see | Likely cause |
|---|---|
| Cracked or crumbling plaster with a dark edge | Long-running leak in an older wall |
| Spots climbing from the floor of a lower-level room | Moisture wicking from the slab or foundation |
| Brown streak under a second-floor bathroom | Drain, toilet seal or shower pan leak |
| Mildew behind a bed on an outside wall | Condensation with little air movement |
| Paint failing around a window after rain | Flashing or sill leak |
Cost factors
Angi's Atlanta cost guide reports most pros charge $12 to $29 per square foot for remediation, with drywall repair at $1,174 to $3,405. HomeGuide's 2026 national ranges put a large wall section at $1,500 to $6,000. Plaster walls, trim that has to be saved in a historic house, wet insulation and cabinet removal all push the price up. Building permits inside city limits go through Jonesboro City Hall on City Center Way, so ask whether your rebuild needs one.
Mold in Walls & Drywall questions in Jonesboro
Is black mold inside a wall more dangerous than other mold?
Is a mold test needed before a wall is opened?
Will the county health department inspect mold in my walls?
Who should hang and finish the new drywall?
More mold services in Jonesboro
Mold in Walls & Drywall nearby
Helpful guides
Sources
- EPA: Mold Cleanup in Your Home
- EPA: A Brief Guide to Mold, Moisture and Your Home
- EPA: Homeowner's and Renter's Guide to Mold Cleanup After Disasters (pdf)
- U.S. Senate Resolution 286 (111th Congress) on the September 2009 Georgia floods (pdf)
- Angi: Mold Remediation Cost in Atlanta, GA
- HomeGuide: Mold Removal Cost (2026)
- Jonesboro, GA building permits directory listing (PermitsAIGE)
- UGA: Georgia County Environmental Health Contact Information (pdf)
- Georgia DPH: Indoor Air Quality/Mold
- Georgia SOS GOALS: Verify Now
- Jonesboro, Georgia (Wikipedia)
Last updated: