When mold turns up in a Jonesboro office, church, shop or historic building, the first moves are to stop the moisture, close off the room and its air supply, and get a written removal plan before anything is torn out. Call the number on this page to be connected with a local mold remediation company in Jonesboro.

Jonesboro's building stock
Jonesboro is Clayton County's small county seat, with about 4,200 residents, roughly 16 miles from Atlanta. Its historic district grew up along the old Macon and Western railroad, and many downtown buildings on Main Street are far older than the offices around them. Older masonry, patched roofs, basements and add-on plumbing give moisture more ways in. Clayton County was among the counties under a state of emergency in the September 2009 floods, so a building that took water then may hide old damage. Churches, law offices near the courthouse, shops along Main Street and event spaces tied to the town's Gone with the Wind history all tend to sit in buildings that have been renovated in layers, which can trap moisture behind newer drywall. The Clayton County environmental health office is in Jonesboro on Battlecreek Road, but Georgia DPH says indoor mold has no enforceable standards, so the owner arranges assessment and cleanup.
What to do right away
- Locate the water. Look above the stain for roof, gutter, window or pipe problems.
- Close the room. Move people and records out and keep the door shut.
- Shut off the HVAC serving it. EPA advises against running a system you suspect is contaminated.
- Dry quickly. Fans and dehumidifiers within 24 to 48 hours, per EPA.
- Protect historic finishes. Ask the company how it will treat plaster, wood trim and brick before demolition starts.
- Get the scope in writing. List areas, containment, removal and the final check.

What you see and what it often means
| What you see | Likely cause |
|---|---|
| Flaking paint and white crust on a lower brick wall | Ground moisture moving through masonry |
| Musty basement storage | Poor drainage around the foundation |
| Brown rings on upper-floor ceilings | Roof or parapet leak |
| Spotting behind restroom fixtures | Supply or drain line leak inside the wall |
Cost factors
Angi's Atlanta cost guide reports $12 to $29 per square foot for typical residential work; commercial bids add containment for occupied space, after-hours labor, HVAC cleaning and rebuild. Historic materials can raise costs because they take more care to clean or match. If rebuilding follows, building permits go through Jonesboro City Hall, 1859 City Center Way. Georgia has no state mold license; ask whether the firm holds a Georgia residential or general contractor license for the rebuild and check it on GOALS Verify Now.
Commercial Mold Remediation questions in Jonesboro
Will the county health department inspect mold in a commercial building?
Can moldy ceiling tiles or carpet be cleaned and reused?
Should the same company test and remediate?
What records should the owner or manager keep?
More mold services in Jonesboro
Commercial Mold Remediation nearby
Helpful guides
Sources
- EPA: Mold Remediation in Schools and Commercial Buildings (pdf)
- EPA: Mold Cleanup in Your Home
- Jonesboro, Georgia (Wikipedia)
- U.S. Senate Resolution 286 (111th Congress) on the September 2009 Georgia floods (pdf)
- PermitsAIGE: Jonesboro, GA building permits directory
- Angi: Mold Remediation Cost in Atlanta, GA
- Georgia SOS GOALS: Verify Now
- Georgia DPH: Indoor Air Quality/Mold
- UGA: Georgia County Environmental Health Contact Information (pdf)
- Angi: How to Hire a Mold Remediation Company
Last updated: