Attic Mold Removal in Union City, GA

If you find mold in a Union City attic, identify the moisture source before anything else, then plan removal of the growth and wet insulation. A remediation company handles cleanup, while a roofer or HVAC technician fixes the source. Call the number on this page to be connected with a local mold remediation company in Union City.

A quick look at Union City

Union City, nicknamed "The Progressive City," was incorporated in 1908 and is a fully urban city of about 27,000 people roughly 12 miles southwest of downtown Atlanta. Its homes deal with the standard metro pressures on an attic: hot, humid summers, frequent thunderstorms and air conditioning equipment that runs for much of the year, often in the attic itself.

What to do now

Find the water. Check the area right above the growth for a roof penetration, a duct, a fan outlet or the air handler.
Stop any active leak with a temporary fix if it is safe, such as clearing a clogged condensate line.
Keep the attic hatch closed so dust and spores do not drift into the house.
Avoid running the AC if the equipment is in the moldy area until it is checked, as EPA advises.
Photograph what you see for your records and any insurance discussion.
Get the source fixed by the right trade and the cleanup done by a remediation company.

Call now to be connected with a local mold remediation company in Union City.

(404) 383-3657

Technician inspecting attic sheathing, attic mold removal in Union City, GA

What the signs usually mean

What you see	Likely cause
Dark growth on the north side of the roof only	Poor ventilation, cooler and shadier surfaces
Wet insulation under the air handler	Clogged drain line or rusted pan
Stain spreading from a plumbing vent	Failed pipe boot
Mold in a strip along the eaves	Soffit vents blocked by insulation or paint
Spotting above a bathroom	Exhaust fan venting into the attic

Cost factors

Angi's Atlanta cost guide reports attic mold remediation at $1,174 to $4,696 in the Atlanta area, with typical rates of $12 to $29 per square foot. The price rises with the area affected, insulation removal and attic access. Replacing decking or framing is construction work: ask whether the company holds a Georgia residential or general contractor license and check it on GOALS Verify Now. Union City's Community Development Department Building Permits Division handles construction permits, including roofing.

Renters can contact Union City Code Enforcement, a separate city department from Community Development, about roof leaks a landlord has not repaired after written notice. Georgia law requires landlords to keep the premises in repair.

Attic Mold Removal questions in Union City

Can I clean attic mold myself?

EPA says homeowners can usually handle less than about 10 square feet. Larger growth or wet insulation is better handled by a remediation company.

What should I check in the attic after a big storm?

Look for fresh wet spots on the decking near valleys, vents and chimneys, and check whether insulation below is damp. Wood that does not dry within a day or two needs attention.

Who fixes the moisture source, the roofer or the mold company?

A roofer handles roof leaks, an HVAC technician handles drain lines and ducts. The remediation company cleans up once the source is addressed.

Will the county health department look at attic mold?

The Fulton County Board of Health's complaints office says it does not respond to mold complaints.