Mold Removal & Remediation in Canton, GA

Mold remediation in Canton means repairing the moisture problem, containing the affected area, removing growth and any drywall, insulation or carpet it has ruined, and drying the structure before rebuilding. EPA says homeowners can usually clean patches under about 10 square feet. Call the number on this page to be connected with a local mold remediation company in Canton.

Why do Canton houses get mold?

Canton is the Cherokee County seat, a former mill town of about 33,000 people roughly 34 miles from Atlanta. The Canton Denim mills closed in 1981, and the city has since grown into an I-575 suburb with a revitalized downtown around Main Street and the Canton Theatre. The Etowah River flows east to west through the middle of the city, and during the September 2009 floods a gauge in the Etowah basin near Canton went above flood stage. Cherokee County was later designated for FEMA Individual Assistance.

Older mill-era houses near downtown tend to have crawl spaces, aging roofs and plumbing that has been patched over the decades. Newer neighborhoods along Riverstone Boulevard and the Bluffs have tighter construction and attic air handlers, where a blocked condensate line can soak a ceiling. Humid summers tie the two together.

Who should I call about mold complaints and permits?

Cherokee County Environmental Health, at 1130 Bluffs Parkway in Canton, receives mold complaints and gives information, but it does not inspect residences because mold has no enforceable standards. For rebuild permits inside city limits, ask the City of Canton which office handles your address. Renters should know Georgia landlords must keep the premises in repair under O.C.G.A. 44-7-13, and requests belong in writing. This is general information, not legal advice.

Call now to be connected with a local mold remediation company in Canton.

(404) 383-3657

Crew carrying sealed bags of mold debris out of a house, mold removal & remediation in Canton, GA

How much can I do myself, and what will it cost?

EPA's cutoff is about 10 square feet. Below that, scrub hard surfaces with detergent and water, wear gloves, goggles and an N-95, and dry the area. Above it, or with growth in walls, ducts or after flooding, a company should set up containment, remove ruined materials and dry the framing.

Angi's Atlanta cost guide reports typical projects at $1,249 to $4,363 and about $12 to $29 per square foot; basements run $587 to $3,522. Tear-out, drying time and rebuild drive the total. Georgia has no state mold license, so ask whether the company holds a Georgia residential or general contractor license for any rebuild and check it on GOALS Verify Now.

A note on the river

Homes on low ground near the Etowah or its creeks should treat any water that sat for more than two days as a mold risk; EPA says to assume growth if drying took longer than 24 to 48 hours.

Mold Removal & Remediation questions in Canton

Can I clean a small patch of mold myself?

Usually, for a patch under about 10 square feet once the moisture is fixed. EPA recommends detergent and water on hard surfaces plus gloves, goggles and an N-95 mask.

What if my house flooded and stayed wet for days?

EPA's disaster guide says to assume mold if a flooded home could not be dried within 24 to 48 hours. Soaked drywall, insulation and carpet usually come out.

Should I test for mold before remediation?

Usually not when mold is visible. EPA says sampling is unnecessary in most cases and there are no federal limits for mold. Testing helps more after cleanup.

What indoor humidity helps keep mold from returning?

EPA recommends indoor humidity below 60 percent, ideally 30 to 50 percent. Keep AC drip pans clean and drain lines flowing.